Fury 250

The Fury 250 uses 2 stock base plates and 4 arm pieces from the ZMR 250 with 25mm round standoffs. All other plates are custom. You may 3D print the arms and base plates, though I've found the arms need to be carbon to stand up to racing level crashes.

Top plate is designed with a built in section for a Frsky D4R-ii and video transmitter. The video transmitter is house at the rear to allow changing video frequencies easily. I use zip ties to hold the antenna and battery connector.

Side panels have 3 raised sections in each hole to improve the fit. Should you find the fit to tight you may wish to drill out the standoff hole with a 1/8" bit,

My FPV camera works great without vibrations, though the next version will update the FPV plate to use rubber dampers without screws. Feel free to remix if you have ideas for an FPV plate with rubber dampers.

Parts List:

http://www.banggood.com/Diatone-M325mm-Aluminum-Standoff-For-ET-180-ET-200-Frame-Kits-20PCS-p-986906.html

http://