Fuse (House Plug) Organiser

Small box to tidy up mains plug fuses. Holds 3 rows of 7 fuses (Main ones being 13A, 5A and 3A). Gets them out of the normally oversized blister packs and stops them rolling around if you keep them loose in your man draw!

Print with bottom of box and top of lid on bed so no need for support. Printed with a 0.4mm nozzle at 0.2 layer height. (I like to use an initial layer height of 0.3 and a 105% initial line width for good bed adhesion). Box and lid can be printed at same time but I like to use only 2 top and bottom layers for lid but add an extra top layer (3 top layers total) for box to make sure of no gaps. Printed with 2 walls and 15% infill (Cura cubic subdivision is strongest). My initial speed is 20mm/s then after a couple of layers is 40mm/s for infill and inner wall and 25mm/s for outer wall for a nice finish. Use a small brim to stop curling (I used 2mm). Your temps will be dependent on your filament but the HobbyKing Yellow am using works well with 205 degrees and a b