Thingiverse
Futaba S3003 Servo
por RSalvage
0
Descargas
3
Likes
0
Makes
This is a model of a Futaba S3003 15g Servo.
I needed to make a "hole" the size and shape of this, so I created it and imported it into my design. As I needed to make a hole for an S3003 to fit in, I increased the size by 1mm x/y/z to make the hole slightly bigger than the unit itself.
The measurements are based on a servo that was on my desk, rather than a data sheet.
I needed to make a "hole" the size and shape of this, so I created it and imported it into my design. As I needed to make a hole for an S3003 to fit in, I increased the size by 1mm x/y/z to make the hole slightly bigger than the unit itself.
The measurements are based on a servo that was on my desk, rather than a data sheet.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
