Thingiverse
Futurama - Planet Express logo
door 3dwalt
120
Downloads
96
Likes
4
Makes
Futurama - Planet Express logo
I printed this at 1½ inches (38mm) top of the logo to bottom, the height is under ½ inches (12.7mm), It is larger side to side than top to bottom (about 1¾ inches) because of the nose cone and flames. After a few hours one of the flames/fins on the outside broke because it was so thin at this scale. Still looks good but one of the fins is shorter than it was when printed.
I am not a painter so the paint job is poor, I did very little sanding on this before I painted it
I printed this at 1½ inches (38mm) top of the logo to bottom, the height is under ½ inches (12.7mm), It is larger side to side than top to bottom (about 1¾ inches) because of the nose cone and flames. After a few hours one of the flames/fins on the outside broke because it was so thin at this scale. Still looks good but one of the fins is shorter than it was when printed.
I am not a painter so the paint job is poor, I did very little sanding on this before I painted it
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
