Futuristic Glow Orb (Dark inspired)

Inspired by the series “DAЯK” ✨🟠Build your own 3D-printed toggleable light orb! 🛠️💡 This project combines 3D printing and simple electronics, allowing you to assemble a small light source that can be switched on and off with a touch. Perfect as a decorative desk lamp, prop, or DIY electronics project.----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------Assembly: ⚡You only need 3 components: 🔋 battery, 💡 LED, and ✋ touch sensor.Currently used: 18650 Li-ion battery, TTP223 touch sensor, 3.4 V LEDCircuit:TTP223 GND → Battery -TTP223 VCC → Battery +TTP223 I/O → LED +LED - → Battery -Attach sensor to white orb part using adhesive. There is dedicated place for Led and battery too but u can change it as u wish. Important: ⚠️Short the A pad on the TTP223 module to enable toggle mode.Make sure the LED voltage matches the battery; a current-lim