Fuzzy Fleefer Nanalan Ornament

This is the Fleefer “Feefer” character from the kid's show Nanalan. Added loop for hanging as an ornament. Fuzzy skin.Requires supports. Prints best on it's side, was not successful printing on feet.Because of the fuzzy skin the support may be slighly difficult to remove.Once the print is done you can run a torch over the feet and warm them to bend them slightly so the toy stands upright.Make sure purging/flushing volumes are set to 1 multiplier so you don't get a black streak across the model where the black eye color transitions to yellow body color. This was a 3D scan of a knitted plush toy Powered by MakerWorld-Image-to-3D (https://makerworld.com/makerlab/imageTo3d)