Thingiverse
FW3A Tactical Ring
door SammysHP
13
Downloads
5
Likes
0
Makes
Hold on tight to your FW3A! This is a tactical ring for the famous FW3A (and similar lights using the same tailcap).
It is based on [my Noctigon KR4 Tactical Ring design](https://www.thingiverse.com/thing:4707744), but recreated with FreeCAD and adapted for the FW3A.
Comes with lanyard hole as well! There are versions with one, two and three lobes.
Print in 0.1 mm to get the correct thickness. No supports required. Assembly is easy: Screw off the head and tailcap, remove a previously installed clip or lanyard ring, put on the tactical ring (flat side towards head) and screw everything back together (starting with the tailcap).
Do you think a tactical ring too much for your FW3A? Then try this [lanyard ring](https://www.thingiverse.com/thing:4938834) which is based on this model.
It is based on [my Noctigon KR4 Tactical Ring design](https://www.thingiverse.com/thing:4707744), but recreated with FreeCAD and adapted for the FW3A.
Comes with lanyard hole as well! There are versions with one, two and three lobes.
Print in 0.1 mm to get the correct thickness. No supports required. Assembly is easy: Screw off the head and tailcap, remove a previously installed clip or lanyard ring, put on the tactical ring (flat side towards head) and screw everything back together (starting with the tailcap).
Do you think a tactical ring too much for your FW3A? Then try this [lanyard ring](https://www.thingiverse.com/thing:4938834) which is based on this model.
SammysHP publiceert ook op
47 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
