Fysetc Spider Cover

I wanted a cover for the Spider board and was already using the DIN mount at https://www.thingiverse.com/thing:4858323. This allows a M3x35mm bolt to pass through the cover, through the board, and into the DIN mount. The holes on both plastic pieces are tight enough to self thread.

Warning! If you have tall heat sinks this will be too short. The -long45 version is probably too long. The "shorter" version is shorter than 45mm but not as short as the original. In addition, those two versions have wider gaps less likely to fill in with wide extrusions widths.

You can see the cover in place in this video: https://www.youtube.com/watch?v=IG5YceFKt48