Thingiverse
G clamp
door Rapidhearts
136
Downloads
88
Likes
0
Makes
G clamp that uses a 5/16" bolt. This G clamp is quite strong. I printed in pla at .2mm at 100% infill and used a hot glue gun to glue the handle and the shoe.
You could easily 3D print the bolt if you wanted to.
Jaw opens to 42mm
Revised:- 2 parts weren't sitting on bed properly and has been fixed. also added a gripper strip at top of jaw. Also have put a hole in the handle to use an extra nut which secures handle much better
You could easily 3D print the bolt if you wanted to.
Jaw opens to 42mm
Revised:- 2 parts weren't sitting on bed properly and has been fixed. also added a gripper strip at top of jaw. Also have put a hole in the handle to use an extra nut which secures handle much better
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
