Thingiverse
G-fun Panel Holder
door Marzucus
0
Downloads
0
Likes
0
Makes
This is a panel holder for G-fun extrusions https://g-fun.jp/
This fitting is for 19mm extrusions and will hold 3mm board or Perspex.
You will need four prints per panel for a standard build but may use more for extended sizes.
You may use two prints for a floating panel like signage. the fit is pretty good.
Depending on the panel material you might be fine using for 5mm thickness on soft boards.
This fitting is for 19mm extrusions and will hold 3mm board or Perspex.
You will need four prints per panel for a standard build but may use more for extended sizes.
You may use two prints for a floating panel like signage. the fit is pretty good.
Depending on the panel material you might be fine using for 5mm thickness on soft boards.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!