G-Meter Enclosure

This is an enclosure for a Raspberry Pico Stack.

Stack consisting of Raspberry Pico, Waveshare 10 dof, Pimoroni Pico Display.
Will make use of a Molex 12Pin connector and can be programmed over USB while installed. To be used as G-Meter, logging Vehicle acceleration/deceleration/cornering. Waveshare 10 dof can be exchanged for GPS module to log speed/distance. All buttons of Pimoroni Display are accessible while installed, te RGB LED is visible through the thin layer on top of the enclosure.

If you intend to use it in a car, print the enclosure in ABS/ASA or similar.

You will need:

1x Raspberry Pico
1x Waveshare 10 DOF
1x Pimoroni Pico Display
4x heat set threaded insert M3
4x 8mm M3 Screws
1x Molex 12Pin Connector
4x 20Pin Strips
2x 10mm M5 Screw