Slicer Discord
G29 Shifter Long Throw Mod – 3D-Druckmodell von Thingiverse Thingiverse
G29 Shifter Long Throw Mod – Bild 1 G29 Shifter Long Throw Mod – Bild 2 G29 Shifter Long Throw Mod – Bild 3
Electronics

G29 Shifter Long Throw Mod

43 Downloads
52 Likes
0 Makes
Zum Modell
Hi! Here is a long throw mod for those who prefer a normal car shifter feel.

ABOUT THIS MOD:

This mod Increases the stock throw of about 6cm to 9cm which is closer to a normal throw of a car shifter.

INSTALLATION:
2x m5 screws required. About 5mm (I cut some longer ones down to 6mm)
Longer ones work too

1. Take off the shift pattern cover
2. Screw out the m4 screw holding the knob on
3. Install the knob to long throw mod
4. Slide the knob assembly to the shifter and secure with two m5 screws
Kategorie
Electronics
Quelle
Thingiverse
Veröffentlicht
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen