Thingiverse
G4 lamp holder support
von TerezzaTech
4
Downloads
4
Likes
0
Makes
This is a simple support for G4 LED lamp holder. If you like it or it has been useful, put a like, any suggestion is welcome and don't forget to post your make. In the upper part there are 4 holes that can be used to fix the piece with the screws or increase the grip of the glue, silicone or resin... If the screws cannot be used. Since the dimensions and the tolerances are very small it is recommended to use a resolution Z = 0.1. The upper part is designed to be used as a diffuser if it is printed in a transparent material or reflector if it is printed in a material with a high index of refraction. After some tests and research we realized that the dimensions of the lamp hoders can vary according to the manufacturer with a tolerance of 1mm, for this reason we decided to oversize a bit the housing hole.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!