Thingiverse
G920 Shifter Knob Mod
von EdSheeran
0
Downloads
2
Likes
0
Makes
I designed this for my racing sim setup.
You can secure it onto the shifter using the original screw, I also added a 3M washer to get better contact on the print.
The fit is tight so it will take some persuading to get on. Once you put it on and off a couple time it will get easier.
The cap is a slim fit no glue is needed.
A 3M bolt should fit in the hole on the cap which will help you get the cap off.
You can secure it onto the shifter using the original screw, I also added a 3M washer to get better contact on the print.
The fit is tight so it will take some persuading to get on. Once you put it on and off a couple time it will get easier.
The cap is a slim fit no glue is needed.
A 3M bolt should fit in the hole on the cap which will help you get the cap off.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
