Thingiverse
Game Boy Color Stand
89
Downloads
83
Likes
1
Makes
Print 1 Base and 2 Legs
The legs "should" push nicely into place and hold the Game boy without coming out. This is all dependant on your 3D printer setup and tolerances. If they are a little loose then a drop of glue will hold them nicely. If they are a to tight then I'm not sure haha
The legs "should" push nicely into place and hold the Game boy without coming out. This is all dependant on your 3D printer setup and tolerances. If they are a little loose then a drop of glue will hold them nicely. If they are a to tight then I'm not sure haha
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
