Game Spinner
von wrighcor
2
Downloads
1
Likes
0
Makes
The Game Spinner allows you to create an updated version of the game spinner for the board game “Mountaineers”. Features of this new spinner include:
3 cm tall peg makes it easier to thread the holes between the mountain holder and game board
Diameter is slightly increased (6 mm) making a more snug fit for the mountain holder to spin on
The base of the game spinner is only 1 mm thick, keeping it from raising the game board
1 piece that is easy to reassemble and disassemble without losing it
3d Printing Tips and Comments
Recommend having exterior wall thickness set to at least 1 mm thick
Recommend infill of 20%
Average print time is ~ 12 minutes
No supports needed
Recommend small brim print of around 5 – 10 mm
3 cm tall peg makes it easier to thread the holes between the mountain holder and game board
Diameter is slightly increased (6 mm) making a more snug fit for the mountain holder to spin on
The base of the game spinner is only 1 mm thick, keeping it from raising the game board
1 piece that is easy to reassemble and disassemble without losing it
3d Printing Tips and Comments
Recommend having exterior wall thickness set to at least 1 mm thick
Recommend infill of 20%
Average print time is ~ 12 minutes
No supports needed
Recommend small brim print of around 5 – 10 mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
