Gameboy Camera D mount adapter

Designed to be combined with a handful of 3rd party products. You will need the following to make this work:

1. You'll need a C-mount to D-mount ring made out of metal with the following specifications: 0.625" x 32tpi female, 1" x 32tpi male, 4.0mm tall ring. These can often be found on ebay or aliexpress, make sure to check the dimensions!

2. You'll need M2 x 3.2mm brass threaded inserts. DO NOT insert these with a soldering iron, resin prints are thermoset. It is designed to be a friction fit, use a small hammer to drive in the inserts. (you can partially screw in an M.2 bolt and hammer the flat bolt-head for the best result)

3. You'll need M.2 bolts in 2 lengths to replace the tri-wing screws holding the rear cap on and to replace the philips head screws holding the camera PCB in place.

3. Depending on your resin and variable 3d print shrinkage you might need 0.1mm metal shims. 25mm outside, 18mm inside diameter should do the trick!

This item was printed using a Creal