Thingiverse
Gameboy Pocket Display Stand
58
Downloads
43
Likes
0
Makes
This is my custom made stand for my Gameboy Pocket which i spent a couple afternoons designing.
After learning a few new things and keeping my DMG stand in mind when designing, I feel I have created an appropriate stand to match my collection, a little brother to the bigger model if you will.
Similar to the GB Original stand, this too has been contoured to as many curves as i could model in the base to maximise stability. This one has turned out even better than id hoped even though its not perfect.
A Creality CR-10S PRO V2 printer was used in producing the product in the images.
No rafts, brims or supports were needed using my machine but this may be subject to change depending on your preferences,
I would recommend around 10 - 15% infill of any sort to support the top surfaces and a print speed around 50mm/s at most to get better clarity on the text.
After learning a few new things and keeping my DMG stand in mind when designing, I feel I have created an appropriate stand to match my collection, a little brother to the bigger model if you will.
Similar to the GB Original stand, this too has been contoured to as many curves as i could model in the base to maximise stability. This one has turned out even better than id hoped even though its not perfect.
A Creality CR-10S PRO V2 printer was used in producing the product in the images.
No rafts, brims or supports were needed using my machine but this may be subject to change depending on your preferences,
I would recommend around 10 - 15% infill of any sort to support the top surfaces and a print speed around 50mm/s at most to get better clarity on the text.
JA-Craft-And-Design veröffentlicht auch auf
24 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
