Thingiverse
Gameboy Pocket Display Stand
by VisualPixel
40
Downloads
34
Likes
0
Makes
A 3D printed stand specifically made for the Gameboy Pocket.
It'll take about 1h30 to print at 50% infill, with ironing enabled and a slow start for better bed adhesion and to avoid warping. But a good glue could probably fix that in no time as well.
Stand dimensions : 51.7 x 18.1 x 92.9 mm
GBP Stand V2 has been properly scaled so you don't need to scale it yourself in your slicer.
If you'd like to buy one you can do so [here](https://visualpixel.co/collections/accessories/products/gameboy-pocket-stand).
It'll take about 1h30 to print at 50% infill, with ironing enabled and a slow start for better bed adhesion and to avoid warping. But a good glue could probably fix that in no time as well.
Stand dimensions : 51.7 x 18.1 x 92.9 mm
GBP Stand V2 has been properly scaled so you don't need to scale it yourself in your slicer.
If you'd like to buy one you can do so [here](https://visualpixel.co/collections/accessories/products/gameboy-pocket-stand).
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
