Thingiverse
Gameboy Zero XY Button Wells
von Rittai3D
138
Downloads
83
Likes
0
Makes
Button Wells with drill hole guide for Gameboy Zero project.
Instructions:
1. Super glue in position the button wells by resting against existing A-B button wells.
2. Drill pilot hole (3mm) using guide from reverse side.
3. Recommend to use stepped drill bit and drill 11mm hole from the front side.
NOTE: Do not drill full size hole 11mm from the reverse side as it can cause the button wells to crack.
UPDATED: REV 1: Reduce height of wells 5mm->4mm and pin from 8mm->5.5mm.
Pin interferes with PCB
Instructions:
1. Super glue in position the button wells by resting against existing A-B button wells.
2. Drill pilot hole (3mm) using guide from reverse side.
3. Recommend to use stepped drill bit and drill 11mm hole from the front side.
NOTE: Do not drill full size hole 11mm from the reverse side as it can cause the button wells to crack.
UPDATED: REV 1: Reduce height of wells 5mm->4mm and pin from 8mm->5.5mm.
Pin interferes with PCB
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
