MakerWorld
Gadgets
Go to Model
GameCube controller back buttons/paddles
0
Downloads
1
Likes
0
Makes
SummaryHere are the buttons i used: https://www.amazon.com/DAOKI-Switch-Momentary-Button-Arduino/dp/B07YKH3TDR/ref=sr_1_6?dchild=1&keywords=Momentary+Push+Button+Micro+Limit+Switch&qid=1629005820&sr=8-6Machine screws mount the buttons to the back controller shell.The switches can be wired by soldering them on the motherboard test traces (use the smallest wire gauge you have) which should be labeled already.Use a piece of 1.75mm printer filament as the axle for the button Print SettingsRafts: Yes Supports: Yes Resolution: 0.1 layer heigth Infill: 55Filament: esun PLA Notes: the button will be a lot quieter if you use a higher infill.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
