Gamecube Controller Stick Cap

A replacement cap for the left analog stick of a Gamecube controller. Depending on your filament these caps should be a bit more durable than OEM, but a little more rigid. I took care to strike a balance between easy installation/removal if required and it staying in place, since I found other models very difficult to install. It will require noticeable effort but should be fairly easy to install on with bare hands, and should not slip or slide around at all while installed.

Designed to be printed in TPU (I used Bambu Lab TPU 95A HF). This model will not snap on to the stick cap if printed in a rigid filament.

I personally think the "concentric" top surface comes out the best