Thingiverse
Gamma Wolves Bases
by EvilGod
13
Downloads
3
Likes
0
Makes
I created these bases for the wargame Gamma Wolves. But they can be handy for any wargame that uses front and back facings and/or side arcs.
The bases consist of a smaller middle part to glue the model to. And they have a larger circle to show the front, side and back 90 degree arcs. In addition they have small notches to mark the front/back 180 degrees.
In my imagination they are some kind of HUD or Radar blip, thats why i printed them in green with 5 walls and no top and bottom layers but with infill.
The small base has an inner circle of 32mm diameter and an outer circle of 50mm diameter.
The medium base has an inner circle of 50mm diameter and an outer circle of 80mm diameter.
The large base has an inner circle of 80mm diameter and an outer circle of 120mm diameter.
All bases are 3mm high.
The bases consist of a smaller middle part to glue the model to. And they have a larger circle to show the front, side and back 90 degree arcs. In addition they have small notches to mark the front/back 180 degrees.
In my imagination they are some kind of HUD or Radar blip, thats why i printed them in green with 5 walls and no top and bottom layers but with infill.
The small base has an inner circle of 32mm diameter and an outer circle of 50mm diameter.
The medium base has an inner circle of 50mm diameter and an outer circle of 80mm diameter.
The large base has an inner circle of 80mm diameter and an outer circle of 120mm diameter.
All bases are 3mm high.
EvilGod also publishes on
23 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
