Thingiverse
Gancio x Termoarredo
by Odo69
20
Downloads
17
Likes
0
Makes
Hello,
this is an hook for bathroom heater.
You just need a 5 x 30mm nut with his bolt.
Just print in PETG
I suggest you do not use PLA unless your radiator stays off, heat will deform it.
it's not hard to mount it, but if you have any doubt give a look to the photos.
UPDATE:
If the gap of your pipes is larger print V2
this is an hook for bathroom heater.
You just need a 5 x 30mm nut with his bolt.
Just print in PETG
I suggest you do not use PLA unless your radiator stays off, heat will deform it.
it's not hard to mount it, but if you have any doubt give a look to the photos.
UPDATE:
If the gap of your pipes is larger print V2
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
