Thingiverse
Garage Door Sensor Mount
von fullburnen
2
Downloads
0
Likes
0
Makes
For mounting reed magnet sensors with a connected Z-Wave/Zigbee sensor to a garage door rail. Be sure to calibrate your X-Y hole compensation.
Printed parts:
* 1x mount front
* 1x mount back
* 2x brackets
Additional parts:
* 2x M6x60mm bolts
* 2x M6x12mm bolts
* 4x M6 nuts
The mount front and back clamp onto the roller track rail and are held in place by the M6x60 bolts.
The two bracket pieces are attached together with M6x12 bolts and are adjustable to match the height of the mount face.
Printed parts:
* 1x mount front
* 1x mount back
* 2x brackets
Additional parts:
* 2x M6x60mm bolts
* 2x M6x12mm bolts
* 4x M6 nuts
The mount front and back clamp onto the roller track rail and are held in place by the M6x60 bolts.
The two bracket pieces are attached together with M6x12 bolts and are adjustable to match the height of the mount face.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
