Garage remote control holder
von mrkmara
3
Downloads
1
Likes
0
Makes
Support to keep the garage remote control in my car.
The "incastro" part has to be assembled befort the remote and then it is designed to be inserted in the A/C vents.
Print in PETG or ABS to avoid deformation due to heat in the car. I printed the "incastro" in PLA because it is no in direct sunlight and is a bit more flexible than PETG.
The "incastro" part has to be assembled befort the remote and then it is designed to be inserted in the A/C vents.
Print in PETG or ABS to avoid deformation due to heat in the car. I printed the "incastro" in PLA because it is no in direct sunlight and is a bit more flexible than PETG.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!