Garbage Bag Holder Knob

Here's a quick kitchen hack that keeps garbage bags from falling into the can. I designed these little knobs in Autodesk Fusion 360 that will hold our drawstrings on the bags. This keeps the bag neat and tidy until it's time to take the garbage out.

**My How-To Video:** https://youtu.be/LlVicAR42HE

**Fusion 360 Model:** http://a360.co/2mR8Q3X

**Project Steps:**
- We need a glue stick, lighter, and our 3d printed knobs.
- Once we glue these to the can, we'll be done.
- The first step is to get a bag and push it down into the bottom of the can.
- Then pull out the drawstrings so we'll know where to mount the knobs.
- Now we can heat up our gluestick and apply a good amount to the knob.
- Locate approximately where it goes and... stick it onto the can.
- Once the glue cools, repeat this for the other side.

And we're done... how easy was that?

Just in case you wanted to know what kind of garbage bags I used, these are 13 gallon drawstring bags from Walmart.

[Inspir