Thingiverse
Garden Hose Holder
728
Downloads
494
Likes
6
Makes
Tired of the hose laying on the ground I made a holder for the spray gun. The clamp has a diameter of 22,5mm and is held together by four M4 screws and nyloc nuts.
The design is basically the same as the one I made for the compressor tool but changed the dimensions to fit the garden hose.
As always, if you find it useful a tiny donation goes a long way to show appreciation. :)
https://www.thingiverse.com/thing:979823
PS: The print was rushed at 145mm/s so the quality of the part in the pictures is not good, but it works. :)
The design is basically the same as the one I made for the compressor tool but changed the dimensions to fit the garden hose.
As always, if you find it useful a tiny donation goes a long way to show appreciation. :)
https://www.thingiverse.com/thing:979823
PS: The print was rushed at 145mm/s so the quality of the part in the pictures is not good, but it works. :)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
