Garden Hose Splitter

This garden hose barb splitter works with 3/4" garden hoses (OD), approx 5/8" ID. Pressing the hose over the barbs locks the hose in pretty well, didn't need any hose clamps but its tough to get the hose out if you will be connecting and disconnecting the hose often. the model can be scaled for differently sized hoses

Going to use these for a basic drip irrigation for a vegetable garden.

I printed in PLA with 5mm retraction and supports "only on the bed" since the barb edges print first. 50% gyroid infill, though 20 or 30% would probably work just fine.