Thingiverse
Garden lantern
door ThingiJay
14
Downloads
11
Likes
0
Makes
This is a simple garden lantern enclosure designed for flat solar ground lights that radiate upwards, such as these:
Just place the light inside the bottom piece and place it in a sunny area. It's designed to either rest on a surface, or it can be hung. If the latter, you'll need four 1-inch #6 wood screws to affix the top piece. And if you're going to do that, you should print the top piece at 100% infill.
Another option is to print them at 60 mm in diameter and drop in a tea light.
Just place the light inside the bottom piece and place it in a sunny area. It's designed to either rest on a surface, or it can be hung. If the latter, you'll need four 1-inch #6 wood screws to affix the top piece. And if you're going to do that, you should print the top piece at 100% infill.
Another option is to print them at 60 mm in diameter and drop in a tea light.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
