Slicer Discord
Garden Scarecrow – 3D-printbaar model van Thingiverse Thingiverse

Garden Scarecrow

14 Downloads
15 Likes
0 Makes
Model downloaden
we set out a garden every year an its always a fight to keep the birds an deer from clipping our planets, use some kinda grease on all the surfaces that see contact an shafts an bolts an hopefully it will hold up. it may be changed at some point, cause all test thus far has been in door so its not seen a lot of run time at this point. at the moment i have a solar panel charging 2 18500 batterys in parallel an a step down convert going from the batterys to the motor. the motor is out of a power wheels so there might end up being a version that uses the gear box from the power wheels but for now this works. would be better off using a motor that isn't high rpm tho cause the motor out of the power wheels is 6v 14000 rpm an im running it at low voltage to keep the speed down but any lower than 1.8 volts an its not enough for the motor to start so i have it set at 2 an it will start own its own now but runs quite a bit faster than i would like but im still going to put it out an start test
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie