Thingiverse
Garden Table Foot
von saeraphin
4
Downloads
4
Likes
0
Makes
A replacement table foot I prepared for a cylindrical garden table foot. I tried reinforcing the original design whilst keeping it lightweight.
For this particular table, the spacing between the inner supports is **28.20mm**, so the table tube should diameter should be no less than that and **not more that a few 100μm** depending on the material used.
Diameter can be adapted by scaling the model.
For this particular table, the spacing between the inner supports is **28.20mm**, so the table tube should diameter should be no less than that and **not more that a few 100μm** depending on the material used.
Diameter can be adapted by scaling the model.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
