Slicer Discord
Gargoyle Hollowface – Modèle 3D imprimable de Thingiverse Thingiverse

Gargoyle Hollowface

par Zagadka
7 Téléchargements
12 Likes
0 Makes
Voir le modèle
This is a little hollow face illusion gargoyle. I sculpted (physically not digitally!) this face a while ago and cast a few in concrete. When I discovered Meshroom it was one of these casts I used as a test piece. It works pretty well, probably better than the video suggests as it had to be unnaturally close to the lens. If you're an old hand at miniature painting it's worth bearing in mind that your dry brushing should be reversed too ie start with the lightest tones in the most recessed areas and then get progressively darker on the ridges. (I have tried a couple of other hollow faces - a predator and grey alien - but this one works by far the best.)
Source
Thingiverse
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Pourquoi ?
supports nécessaires · post-traitement important
Monobloc Supports requis Visserie requise
Supports 2/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 2/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Post-traitement
Peinture, Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection