Thingiverse
Garlic and Ginger Grater
door Ragkov
11
Downloads
17
Likes
0
Makes
Inspired on COLOURWORKS brights Garlic and ginger grater (https://www.sophiecharles.co.uk/cw-garlic-and-ginger-grater/) I made my own vesion to see how it works. This grater has bigget teeths than the original. I might do a version 2.0 that looks more alike.
It doenst really grate the garlic, you get more of a puré, but still works fine
In my print I used only 3 (0.13 mm) bottom and top layers and it looks quite cheap. I would recomend increasing them to at least 6 each
Yo need to use a lot of suppont on all the bottom part (I used 3mm support pilar resolution), but at the end it gives it a rough finish to where you grab that is nice
It doenst really grate the garlic, you get more of a puré, but still works fine
In my print I used only 3 (0.13 mm) bottom and top layers and it looks quite cheap. I would recomend increasing them to at least 6 each
Yo need to use a lot of suppont on all the bottom part (I used 3mm support pilar resolution), but at the end it gives it a rough finish to where you grab that is nice
Ragkov publiceert ook op
6 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
