Thingiverse
Garlic Sign
by blecheimer
0
Downloads
1
Likes
0
Makes
I planted a little bit of garlic in my garden. Just in case of a vampire invasion - you never know…
To find the garlic again later I designed a simple sign.
Print preparation:
Make sure that your print bed is clean and grease-free and use a quality brand filament. If the print result is too brittle try drying your filament. Wet filament can be fragile.
Print settings:
You need a multi-material system for this four-colour-print. Simply use standard settings in the slicer.
If you want to support me you can leave a tip at ko-fi.com/blecheimer.
Disclaimer:
This work by blecheimer is licensed under "CC BY-NC-SA 4.0". The shown model must not be used commercially.
Copying this model to other 3D printing websites is not allowed without my permission.
The garlic motif is licensed under "CC0 1.0 Deed" and can be found on https://freesvg.org.
To find the garlic again later I designed a simple sign.
Print preparation:
Make sure that your print bed is clean and grease-free and use a quality brand filament. If the print result is too brittle try drying your filament. Wet filament can be fragile.
Print settings:
You need a multi-material system for this four-colour-print. Simply use standard settings in the slicer.
If you want to support me you can leave a tip at ko-fi.com/blecheimer.
Disclaimer:
This work by blecheimer is licensed under "CC BY-NC-SA 4.0". The shown model must not be used commercially.
Copying this model to other 3D printing websites is not allowed without my permission.
The garlic motif is licensed under "CC0 1.0 Deed" and can be found on https://freesvg.org.
blecheimer also publishes on
237 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
