Garmin Edge handlebar mount

The Body should be printed in the orientation as in the picture with the flat face down, the hinge laid on the side and the varia adapter with the hex nut holes pointed up. Both parts need support only from the printbed but they still come out very nice because the supported faces are not visible in the end. For the Body I used 15 top layers, which adds up to a thickness of 3mm, because most of the forces are pulling on that.

Required parts:
Srew M3 x 15mm ISO 4762
Nut M3 ISO 4032
Nail diameter 2mm
A piece of inner tube for clamping diameter