Garmin Etrex20 replacement buttons

This print is used for replacing the buttons of the Garmin Etrex20. The stock buttons will wear out over time.

Important!:
To install these you need to trim the plastic on the inside of the case. When you gently trim the edges of de buttons in the case, the prints will fall seamlessly in place. When this is not done, the button holders will protrude on the inside and prevent the printboard from being placed back.

If the buttons cannot be pressed, you can trim the sides of the buttons with sandpaper, to ensure smooth fitment.

There is no need to use glue for placing the buttonholder.

Printspeed: 25mm/s