Thingiverse
Garmin Frame Mount
von edvinmellergard
95
Downloads
74
Likes
1
Makes
Frame mount for Garmin Edge series GPSes. Less clutter on your handlebars and less chance of breaking it in a crash.
Instructions:
1. Print at 100% infill with the bottom down.
2. Break away the supports
3. Put a sand paper on your frame and drag the mount back and fourth until you sanded away enough material so that the mount matches your frame.
4. Clean the mount and your frame with some acetone or other degreaser.
5. Use double sided tape to attach it.
6. Make sure you use the "keeper cord" included with the gps incase it falls of :)
Enjoy!
Instructions:
1. Print at 100% infill with the bottom down.
2. Break away the supports
3. Put a sand paper on your frame and drag the mount back and fourth until you sanded away enough material so that the mount matches your frame.
4. Clean the mount and your frame with some acetone or other degreaser.
5. Use double sided tape to attach it.
6. Make sure you use the "keeper cord" included with the gps incase it falls of :)
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
