Garmin Livescope Turret Pointer – 3D printable model from MakerWorld

MakerWorld

Sport & Outdoors

Garmin Livescope Turret Pointer

by gluFPV · Sport & Outdoors

40 Downloads

20 Likes

9 Makes

Go to Model

I made a DIY turret for my livescope setup. I needed a point for the top to indicate which way the beam was directed. Fits an m6 bolt thru the base after I tapped it. I printed in ASA.It has two pieces so you can print it in contrasting colors. I chose black for the base and yellow for the top. Glued together. The bottom is like a “cup” so I could fit a rubber seal in there in an attempt to protect my electric motor from as much moisture.

garmin sonar livescope live scope ffs forward facing sonar minn kota lowrance humminbird fish finder fish fishing

Category

Sport & Outdoors

Source

MakerWorld

Published

26.04.2025

Updated

30.04.2026

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format

STL

Material

ASA

Post-processing

Hardware

Software

Cura, PrusaSlicer, or similar

Same designer, more platforms

gluFPV also publishes on

9 additional models across 1 more platforms

♥ 301 ↓ 1,938 ⚒ 24

No ratings yet

No comments yet – be the first!

Similar Models

6 Suggestions

Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee

DE EN FR ES IT NL