Thingiverse
Gas cap strap
von Terminus
22
Downloads
24
Likes
0
Makes
Gas cap retaining strap
This cures a minor but persistent annoyance.
My car is an unusual make and I'm posting this only for the sake of the idea.
No special instructions.
This part has a large footprint, roughly a 5 inches square. The factory part was too wide for the platform, and I had to curve the piece connecting the two major sections.
Make it out of nylon for flexibility, strength and chemical compatability.
This cures a minor but persistent annoyance.
My car is an unusual make and I'm posting this only for the sake of the idea.
No special instructions.
This part has a large footprint, roughly a 5 inches square. The factory part was too wide for the platform, and I had to curve the piece connecting the two major sections.
Make it out of nylon for flexibility, strength and chemical compatability.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!