Thingiverse
Gate/Fence Fork Latch
von zamanlui
12
Downloads
8
Likes
0
Makes
Our gate latch wasn't quite bit enough and I wasn't able to find one that fit our fence, so I made this mode. I will clean up the OpenSCAD file and make it parametric and upload that soon.
Original has a 3.5" width, 3" version has a 3" gap and a lower footprint (1/2" instead of 1" tall).
Original has a 3.5" width, 3" version has a 3" gap and a lower footprint (1/2" instead of 1" tall).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!