Thingiverse
Gate Stopper
door Vspereira
0
Downloads
0
Likes
0
Makes
Door Stopper for a gate.
Made it round because as it will be on the flour, people can kick it. So, rounded (without any edges) should be less dangerous.
Pins (just need 2) to connect upper part with bottom part.
Center hole is for the screw (may need to enlarge the hole).
Will be needed to enlarge holes from pins.
Made in PLA but would be good in TPU or PTEG.
Made it round because as it will be on the flour, people can kick it. So, rounded (without any edges) should be less dangerous.
Pins (just need 2) to connect upper part with bottom part.
Center hole is for the screw (may need to enlarge the hole).
Will be needed to enlarge holes from pins.
Made in PLA but would be good in TPU or PTEG.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
