Thingiverse

Gatehunter Neo

par Dave_C_FPV

90 Téléchargements

113 Likes

0 Makes

The Gatehunter Neo is an all new performance frame designed for setups with 20x20 stacks and bigger motors (2207 and more). Using only 20x20 stacks made it possible to design this frame to be very aerodynamic and light (66g). The increase in top speed and acceleration is absolutely noticeable and it corners like there are no laws of physics holding it back ;-)

**Please note:** Be very careful to only maiden these setups in a safe open space. Especially on 6S, the betaflight stock PIDs are way too high and the flight controller might accelerate the quad uncontrolled. I recommend reducing them all by 30-40% to start with and then work you way up to da good tune.

**Frame Specs:**
- 5" stech X
- 66g including everything
- 20x20 stacks only
- 16x16 motor mounts
- 19mm cams or 14mm with adapter
- Canopy designed for Micro Axii FPV antenna

**My recommended high performance Setup**
(only 255g w/o LiPo despite the massive motors!)
- **Motors:** [Rcinpower 2207+ 1860kV](http:/

canopy Dave c fpv DIY Drone drone drone racing fpv FPV Canopy FPV Frame gatehunter micro axii miniquad racing drone canopy Dave c fpv DIY Drone drone drone racing fpv FPV Canopy FPV Frame gatehunter micro axii miniquad racing drone

Source

Thingiverse

Ce qu'il faut pour imprimer: Débutant Confiance faible

Monobloc

Supports 1/3

Assemblage 0/3

Réglages 1/3

Taille du plateau 0/3

Post-traitement 0/3

Imprimante

FDM / FFF

Format de fichier