MakerWorld
Test Models
Go to Model
Gcode for manual change Zoffset+Faster first layer
37
Downloads
7
Likes
2
Makes
First layer to be printed + a line of Gcode to change the height of the nozzle from the table (ON YOUR OWN RESPONSIBILITY) MAX tested by me -0.03, I think up to MAX -0.05 can be tried but I have not tried it and i will not. The value must be minus, place the ruler at the very bottom in the filament settings"SET_GCODE_OFFSET Z=-0.02 MOVE=O"If you like my work I will be grateful for your support, I will be grateful for everythiBoost MeIt costs nothing to be kind, but it can mean everything to someone else. You can never go wrong being kind.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
