Thingiverse
GE Microwave Drive Cog
von milesvw
5
Downloads
1
Likes
0
Makes
I had a plate that didn't fit my GE microwave cog (White color).
The slim spindle (on left) by Usuariu probably would have worked if it was 4MM taller. However I took the opportunity to make the drive cogs bigger too.
This is for using with a plate having approximately 18mm hole in the center of the drive lugs.
Attaching to a GE Microwave that normally uses a WB39X10032 plate.
Work in progress. (I added another 2mm to the top and a 'bearing' surface to the bottom of the tri-flange; I may have the wrong wheels supporting my plate.)
I would print at 0.12mm layer height 4 walls and 60% infill
Flip it upside down in your slicer to print it standing on its "head"
The slim spindle (on left) by Usuariu probably would have worked if it was 4MM taller. However I took the opportunity to make the drive cogs bigger too.
This is for using with a plate having approximately 18mm hole in the center of the drive lugs.
Attaching to a GE Microwave that normally uses a WB39X10032 plate.
Work in progress. (I added another 2mm to the top and a 'bearing' surface to the bottom of the tri-flange; I may have the wrong wheels supporting my plate.)
I would print at 0.12mm layer height 4 walls and 60% infill
Flip it upside down in your slicer to print it standing on its "head"
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
