Gear backing

So I was inspired by this project along with (http://www.thingiverse.com/thing:221278). I took zheng3's design (http://www.thingiverse.com/thing:185155), printed it at 200% (but only 100% z-axis) and printed one large gear and 3 of the small gears. I then created a 3-pointed backing and some caps to fit on either side of the magnets to hide them.

I have uploaded the backing and caps, if you want to use them with zheng3's project be sure to print them at 50% size.

I am using a Printrbot Simple Metal using black PLA.

No supports needed, infill is whatever you want.

You can see the full project here at my Hackaday.io project page: https://hackaday.io/project/9137-lapel-gears