Gear Guard Gary

Gear Guard Gary. Use tuned print profile. There are manual supports for the overhangs on the pants, belt, and hands. The Fur prints well as is, since the conical points are attached to each layer they start on. This creates solid support for each protruding fur spike. The colors were recently updated to official colors that Bambu Labs currently offers. Once I get a chance to reprint with these new colors, I will update the photos. NOTE: Make sure to scale the model to a sufficient size. The teeth are small. Depending on your nozzle size, layer height, etc., the teeth may be too small to slice properly. Double check that the model is large enough that both show up in the slicer. This seems to affect the model when scale at 100mm in the Z or lower.