Gear Ring - no supoorts

This is from https://makerworld.com/en/models/196552-gear-ring-a-working-model?from=searchGear Ring - A working model I have disassembled the rings from the barrel. No supports are needed to print the rings or the barrel, but the rings will have to be put on the barrel before the print finishes. Instructions below are from the original model. I like this model, but the top ring did not print well, even with lot of supports. So I found another way. It prints great with .2mm nozzle and .1mm layer height. BOM1x - Gear ring main body with the outer rings6x - Gears6x - StudsPLA or any kind of plastic cement. Slow curing is highly recommended.AssemblyEnsure all the gears are oriented correctly and ready to be installed.Test fit the stud through the gear and correctly installedMove the outer rings on the main body to the outer edgeTest fit the stud through the gear and into the main bodyApply very small amount of cement to the recessed hole in the main bodyInstall the stud through the gear an