Thingiverse
Geared Extruder 2
door JobSmolders
15
Downloads
6
Likes
0
Makes
Geared Extruder for 3mm Filament
*********************************************************************************************************
April-10-2018
This Extruder works very well and worked many hours for me now.
Later I placed it in a closed housing for ABS printing (temps inside the housing up to 45°C) and came to the conclusion the main body warped slowly.
Conclusion:
This extruder works very well outside an enclosure.
Inside an enclosure with high temperatures it does not. Instead you could use : https://www.thingiverse.com/thing:2855872
*********************************************************************************************************
This is a Geared Extruder that can be used for 3mm filament.
Of course you also could use it for 2.85 and 1.75 mm :-)
I made this one to fit to the K8200 of Velleman because the old extruder did not want to go any more. The gear ratio is still the same as the old one so there is no change needed in the firmware
The filame
*********************************************************************************************************
April-10-2018
This Extruder works very well and worked many hours for me now.
Later I placed it in a closed housing for ABS printing (temps inside the housing up to 45°C) and came to the conclusion the main body warped slowly.
Conclusion:
This extruder works very well outside an enclosure.
Inside an enclosure with high temperatures it does not. Instead you could use : https://www.thingiverse.com/thing:2855872
*********************************************************************************************************
This is a Geared Extruder that can be used for 3mm filament.
Of course you also could use it for 2.85 and 1.75 mm :-)
I made this one to fit to the K8200 of Velleman because the old extruder did not want to go any more. The gear ratio is still the same as the old one so there is no change needed in the firmware
The filame
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
