Thingiverse
Gearhead Extruder
von TrinityLabs
16
Downloads
38
Likes
3
Makes
Extruder for gearhead motor like http://www.phidgets.com/products.php?category=23&product_id=3317_1 or Makergear's gearhead.
T1 extruder guidler - like the Greg's guidler, but enclosed
T1 extruder for car v0.9 - Designed to mount on TrinityLabs rail.
T1 extruder for car v0.9b - same as above, but with secondary guidler on the extruder body.
T1 extruder v0.9 - same as the above extruders, but designed for a standard reprap carriage and not the rail.
T1 idler - this is IDENTICAL to the Greg's guidler
T1 extruder for both nema 11 and nema 17 gearheads is the same as the 1st file, except it has a 2nd set of holes for a nema 11 gearhead.
The extruders include holes intended to mount a 40mm fan aimed at the hot end.
T1 extruder guidler - like the Greg's guidler, but enclosed
T1 extruder for car v0.9 - Designed to mount on TrinityLabs rail.
T1 extruder for car v0.9b - same as above, but with secondary guidler on the extruder body.
T1 extruder v0.9 - same as the above extruders, but designed for a standard reprap carriage and not the rail.
T1 idler - this is IDENTICAL to the Greg's guidler
T1 extruder for both nema 11 and nema 17 gearheads is the same as the 1st file, except it has a 2nd set of holes for a nema 11 gearhead.
The extruders include holes intended to mount a 40mm fan aimed at the hot end.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
